4801020140 Wabco EBS Trailer Modulator - Does it make sense to rebuild?

Remanufacturing of the EBS trailer modulator "named" by Wabco to part number 4801020140 below usually fails due to a damaged housing.

Unfortunately, the whole 480102 ... series can be said to get a lot of dirt due to its position mounted on the vehicle.
Especially salt or other chemicals used during the winter will test the life of the aluminum housing.
If it "survives" this period, it is suitable for renovation to the greatest delight of end-users. As this is a relatively expensive unit, we can provide a competitive price to our customers by refurbishing the modulator.

The above applied to end-users, i.e. vehicle owners!

Unfortunately, this no longer applies to retail and wholesale, for the following reasons!

If you buy a new 4801020140 there only the basic parameter files are installed/configured if you like "the unit is down".
After the installation in a workshop, its specific parameters must be set, which can only be carried out in the installed state under real conditions.
Once this is done, the unit will have custom settings that apply only to that particular vehicle.
The settings can be copied later during a possible upgrade (from unit "A" to unit "B"), but in practice, this can only be done for end users. In this case, we can communicate with the modulator and we can also test electrically, and then finally comes the pneumatic test bench run.

Unfortunately, the basic parameter file cannot be set, we cannot "push back" the already trained, trained trailer modulator.

PS .:Wabco has already "snapped" in some places that electronics can become unstable in the vast majority of cases around 700,000km, so there isn't much point in renovating.
Sledovať ďalej →

The "weakest point" of the LS3907

The "weakest point" of the LS3907

In this short blog, we reveal the possible weakest point of the LS3907 Cluth Compressor.
Sledovať ďalej →

Arvin Meritor Identification

Arvin Meritor Identification

Sometimes the exact identification process for Arvin Meritor calipers can be hard if someone can't find the part number. However you can find 3 casting number on the Meritor calipers. Which are can be used to identify the caliper.

You will find the first number on the "head" of the caliper : 

The other casting number you can find near the "tappets" :

The last one is on the "back" of the caliper : 

For us, if we are able to get these three numbers we can easily tell anyone which caliper is it. For the "non-professional" eye can be a bit hard to find them but with these pictures, we can simplify the process.
Sledovať ďalej →

Úplne nová webová stránka, jednoduchý prístup

A completely new website, easier access

Aktívna práca na našej webovej stránke

Sledovať ďalej →